DIY REPAIR GUIDE — HONDA ODYSSEY, PILOT, ACCORD V6, RIDGELINE 2006–2014, ACURA MDX, TL AN
Honda V6 Timing Belt & Water Pump Replacement
Honda’s 3.0 and 3.5 V6 engines use a rubber timing belt that must be replaced on schedule.
321 Rexdale Blvd #4, Etobicoke, ON M9W 1R8
Mon–Fri 8am–5pm · (416) 742-4521
⚡ Servicing your car at an independent shop does not void your vehicle warranty — protected under Canadian consumer protection law.
By the Radman Auto Repair team, independent auto repair in Etobicoke since 1999 · Updated November 2026
Honda’s 3.0 and 3.5 V6 engines use a rubber timing belt that must be replaced on schedule. If it breaks, the valves hit the pistons and the engine is badly damaged. The water pump, tensioner and idlers are replaced at the same time.
Quick answer: Replace the timing belt on a Honda V6 when the Maintenance Minder shows it (code 4) or at about 7 years. Replace the water pump, tensioner and idlers at the same time, align the timing marks exactly, turn the engine by hand twice to confirm, then refill and bleed the coolant.
At a glance
- Vehicles: Honda Odyssey, Pilot, Accord V6, Ridgeline 2006–2014, Acura MDX, TL and RL (J-series V6)
- DIY difficulty: Advanced
- Time: about 5 hours
- Tools: socket set and breaker bar, crank pulley holder, torque wrench, floor jack and wood block, drain pan, tensioner pin
- Parts: timing belt kit (belt, tensioner, idlers), water pump, Honda Type 2 coolant, crank bolt (if specified)
- Codes & warning lights: Maintenance Minder code 4
- Recalls: check your VIN first; some of these problems are covered by recalls, campaigns or extended warranties
Symptoms
Maintenance Minder 4 the timing belt service is due.
Age the belt is older than about 7 years.
Coolant leak a weeping water pump.
Noise whine or rattle from the tensioner.
Belt condition cracks or oil on the belt.
What Causes It
Interference engine a broken belt damages the valves.
Rubber ages belts weaken with age, not just kilometres.
Water pump the pump is driven by the belt and wears with it.
Before You Start
- Park on level ground, set the parking brake and chock the wheels. Never work under a car held up only by a jack: use rated jack stands.
- Let the engine and exhaust cool before you touch them; coolant systems are under pressure when hot.
- Wear safety glasses and gloves, and disconnect the 12V battery before unplugging electrical parts or working near airbags.
- Check for open recalls on your VIN (Transport Canada or the manufacturer’s site) before you buy parts: a recall repair is free at the dealer.
- Support the engine with a jack and wood block before removing the engine mount.
- Never turn the engine with the starter while the belt is off.
Step-by-Step: Honda V6 Timing Belt
- Prepare. Disconnect the battery, drain the coolant and remove the drive belt.
- Support the engine. Support the engine and remove the side engine mount.
- Remove the covers. Remove the crank pulley and timing belt covers.
- Align the marks. Turn the engine to top dead centre and align the cam and crank marks.
- Lock the tensioner. Pin the tensioner and remove the old belt.
- Replace parts. Replace the water pump, tensioner and idlers.
- Fit the new belt. Install the belt with marks aligned, then release the tensioner.
- Check by hand. Turn the engine two full turns by hand and confirm the marks line up.
- Reassemble and refill. Refit everything, torque the crank bolt, refill and bleed the coolant.
When to Stop and Bring It In
- The marks don’t line up after two turns.
- The engine won’t turn by hand: stop immediately.
- You don’t have the crank pulley holder or torque wrench.
- You’re not confident about timing: a mistake can destroy the engine.
Not sure, or out of time? Radman Auto Repair in Etobicoke does this repair every week. Book online or call (416) 742-4521.
Also Known As
Searched as “Honda Odyssey timing belt”, “Pilot timing belt replacement”, “Accord V6 timing belt”, “Honda maintenance code 4”, “J35 timing belt” and “Honda timing belt water pump”.
Frequently Asked Questions
When should the Honda V6 timing belt be replaced?
When the Maintenance Minder shows code 4, or about every 7 years.
Is the Honda V6 an interference engine?
Yes. A broken belt lets the valves hit the pistons.
Should I replace the water pump too?
Yes. It is driven by the timing belt and the labour overlaps.
How long does it take?
About five hours for a skilled DIYer.
What coolant should I use?
Honda Type 2 coolant.
What else should be replaced with the timing belt?
The water pump, tensioner, idler pulleys and often the drive belt. Check the cam and crank seals for leaks and replace them if they are wet.
What if my Honda belt breaks while driving?
The engine stops immediately and the valves are usually damaged. It needs to be towed and the cylinder heads inspected.
See also Honda Repair & Service, Timing Belt vs Serpentine Belt, Coolant Leak Repair, Acura Repair & Service.






Prefer to Have It Done? Radman Auto Repair, Etobicoke
Independent auto repair in Etobicoke since 1999. We fix what this guide covers, explain what we find, and keep the old parts for you to see.
This Service Includes
✓ Timing belt replacement
✓ Water pump replacement
✓ Tensioner and idler replacement
✓ Coolant refill and bleed
